Cisco Systems 124792, 124778, 159330 manual Replace a Rectifier, Removing a Circuit Breaker

Chapter 3 Component Replacement

3.2.4 Replace a Rectifier

Figure 3-8 Removing a Circuit Breaker

	124757
Step 5	Remove the alarm cable connections from the rear of the breaker (Figure 3-8).
Step 6	Pull the breaker straight out from the 1RU Distribution Shelf.
Step 7	To reinstall a replacement 1RU Distribution Shelf see the “2.2.2 Install the 1 RU Distribution Shelf”
	procedure on page 2-6.

3.2.4 Replace a Rectifier

Note For more information on uninstalling a rectifier, see the “4.2.2.3 Remove Modules” section on page 4-3.

Step 1 Locate the rectifier that is to be removed.

Step 2 Loosen the mounting screws to allow the rectifier handle to open (Figure 3-9#1).

Step 3 Grasp the top of the handle and pull down until the handle locks into the open position (Figure 3-9#2).

Cisco AC/DC Power System User Guide, R1.0

3-8 May 2006