Cisco Systems 124792, 124778, 159330 manual Safety Recommendations, Statement

Chapter 1 Introduction

1.2 Safety Recommendations

Table 1-8 Compliance Specifications

Compliance	Description
Radiated EMC	EN 61000-6-2, EN 61000-6-3, FCC Part 15 Class B
EMC	EN 61000-6-2, EN 61000-6-4
Safety	CSA C22-2 No. 60950-1, UL 60950-1 and
	IEC60950-1/EN60950-1
ESD Immunity	EN61000-4-2
RF Immunity	EN61000-4-3
Surge Immunity	IEC/EN61000-4-5
Fast Transient/Burst	IEC/EN61000-4-4
Immunity
Immunity	EN61000-4-2
ETSI	300-386-TC

1

1.2 Safety Recommendations

Any device that uses electricity requires proper guidelines to ensure safety.

Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030

Warning This unit is intended for installation in restricted access areas. A restricted access area can be accessed only through the use of a special tool, lock and key, or other means of security.

Statement 1017

•The Cisco AC/DC Power System should only be installed or serviced by qualified personnel.

•An ESD wrist strap is included to protect sensitive electronics and should be connected to a metal surface to act as a ground. This ensures that all components have the same charge. An ESD wrist strap should be used when working with internal components that are installed in the shelf. The wrist strap connects at the rear of the system shelf as shown in Figure 1-8. If rear access is not available, the ESD wrist strap can be connected to the shelf mounting ears or the controller faceplate thumbscrews.

Cisco AC/DC Power System User Guide, R1.0

1-8 May 2006