Cisco Systems 15310-MA manual MS NE/FE 1+1, Lmsp NE 1 PJC NE Path NE/FE4 4, 11-26

Chapter 11 Performance Monitoring

Performance Monitoring for Optical Ports

Figure 11-9 PM Parameter Read Points on the STM1 Port

ONS 15310-MA SDH

STM1 Port Cross Connect STM-N

Pointer Processors

RS-EB

RS-ES

RS-SES

BTC

ASIC

MS-EB

MS-ES

SMS-ES

MS-UAS

PPJC-Pdet

NPJC-Pdet

PPJC-Pgen

VC CV-P VC ES-P VC

VC SES-P VC UAS-P

VC CV-PFE VC ES-PFE VC FE

Path Level

NPJC-Pgen PJC-DIFF-P PJCS-PDET-P PJCS-PGEN-P

PMs read on PMC

VC SES-PFE

VC UAS-PFE

PMs read on BTC ASIC

271808

The PM parameters for the STM1 ports are listed in Table 11-11. The listed parameters are defined in Table 11-2 on page 11-4.

Note The parameters listed below are applicable for STM1 optical and Electrical SFPs.

Table 11-11	STM1 Port PM Parameters
			MS (NE/FE) 1+1		VC4 and VC4-Xc HP
RS (NE)		MS (NE/FE)	LMSP (NE)1, 2	PJC (NE)3	Path (NE/FE44)5
RS-BBE		MS-BBE	MS-PSC (1+1)	HP-PPJC-Pdet	HP-BBE
RS-EB		MS-EB	MS-PSD	HP-NPJC-Pdet	HP-BBER
RS-ES		MS-ES		HP-PPJC-Pgen	HP-EB
RS-SES		MS-SES		HP-NPJC-Pgen	HP-ES
RS-UAS		MS-UAS		HP-PJCS-Pdet	HP-ESR
				HP-PJCS-Pgen	HP-SES
				HP-PJCDiff	HP-SESR
					HP-UAS

1.For information about troubleshooting subnetwork connection protection (SNCP) switch counts, refer to the “Alarm Troubleshooting” chapter in the Cisco ONS 15310-MA SDH Troubleshooting Guide. For information about creating circuits that perform a switch, refer to Chapter 7, “Circuits and Tunnels”.

2.MS-SPRing is not supported on the STM-1 card and STM-1E card; therefore, the MS-PSD-W, MS-PSD-S, and MS-PSD-R PM parameters do not increment.

3.In CTC, the count fields for the HP-PPJC and HP-NPJC PM parameters appear white and blank unless they are enabled on the Provisioning > Line tab. See the 11.3 Pointer Justification Count Performance Monitoring section.

	Cisco ONS 15310-MA SDH Reference Manual, Release 9.1 and Release 9.2
11-26	78-19417-01