Cisco Systems 15310-MA manual 1 E121E3DS33 and E163E3DS33 Card-Level Indicators

Chapter 2 Card Reference

E1_21_E3_DS3_3 and E1_63_E3_DS3_3 Cards

seven E1 ports from 59 to 65. You cannot use connectors 57 and 58, because the line timing configuration on the ASIC might disturb the data path in these two ports. WBE Port 63 is accessed by AMP Champ-3 connector Port 65. This restriction is not applicable to the E1_21_E3_DS3_3 card.

Refer to the 32xE1-LFH-RJ45 Panel and 32xE1-LFH-1.0/2.3 Panel sections of Cisco ONS 15305 Installation and Operations Guide, Release 2.0 for information about patch panels.

Note When you use a third-party patch panel, you need to use an unconnectored cable.

Figure 2-8	BIC Configuration on WBE Cards
						J5-BITS2		J7-ALM OUT
	RTN -48VDC PWR B	J1-LAN J2-CRFT	J3-UDC	J4-BITS1			J6-ALM INPUT		PWR A -48VDC	RTN
		P/N						P/N
		COO			PID VID	PID VID		COO
			E1				E1
E1s			OUT				OUT			E1s
			J21				J8
1-28			E1				E1			1-28
					S/N	S/N
			IN				IN
			J22				J9
			E1		CLEICODE	BAR CODE	E1
E1s			OUT				OUT			E1s
			J23				J10
29-56										29-56
			E1		BAR CODE	CLEI CODE	E1
			IN				IN
			J24				J11
E1s			E1				E1			E1s
			OUT				OUT
			J25				J12
59-65										59-65
			E1				E1
			IN				IN
			J26				J13
		J29-OUT J30-IN	J31-OUT				J15-IN	J16-OUT	J17-IN
	1	2	3				1	2	3
	J27-OUT J28-IN		J32-IN				J14-OUT		J18-OUT J19-IN
		J33-HD DS3						J20-HD DS3		271767
2.6.1 E1_21_E3_DS3_3 and E1_63_E3_DS3_3 Card-Level Indicators
The E1_21_E3_DS3_3 and E1_63_E3_DS3_3 cards have three card-level LED indicators (Table 2-10).

Cisco ONS 15310-MA SDH Reference Manual, Release 9.1 and Release 9.2

78-19417-01 2-17