Chapter 2 Card Reference
2.4.1 CE-MR-6 Card-Level Indicators
The
Table
| Description |
|
|
FAIL LED (Red) | The red FAIL LED indicates that the card processor is not ready or that a |
| catastrophic software failure occurred on the |
| boot sequence, the FAIL LED blinks until the software deems the card |
| operational, then it turns off. |
|
|
ACT/STBY LED | The ACT/STBY LED provides the operational status of the |
(Green) | the ACT/STBY LED is green, it indicates that the |
| and the software is operational; otherwise, it is off. |
|
|
2.4.2 CE-MR-6 Port-Level Indicators
The
Table
| Description |
|
|
Off | No link exists to the Ethernet port. |
|
|
Steady amber | A link exists to the Ethernet port, but traffic flow is inhibited. For |
| example, a lack of circuit setup, an error on the line, or a disabled port |
| might inhibit traffic flow. |
|
|
Solid green | A link exists to the Ethernet port, but no traffic is carried on the port. |
|
|
Flashing green | A link exists to the Ethernet port, and traffic is carried on the port. The |
| LED flash rate reflects the traffic rate for that port. |
|
|
2.5 ML-100T-8 Card
This section describes the features and functions of the Layer 2 10/100 Ethernet card, the
Note The
Cisco ONS
| ||
|