
Chapter 3 Installing the Switch
Connecting DC Power to the Catalyst 4900M Switch
If the LEDs or show power command indicate a power or other system problem, see Chapter 4, “Troubleshooting the Installation,” for troubleshooting information.
Connecting DC Power to the Catalyst 4900M Switch
|
|
|
| Follow these steps and warnings when connecting DC power to the | ||
|
|
|
| Catalyst 4900M switch: | ||
|
|
|
|
| ||
| Warning | Before performing any of the following procedures, ensure that power is | ||||
|
|
|
| removed from the DC circuit. Statement 1003 | ||
|
|
| ||||
|
|
|
|
| ||
| Warning | This unit is intended for installation in restricted access areas. A restricted | ||||
|
|
|
| access area can be accessed only through the use of a special tool, lock and | ||
|
|
|
| key, or other means of security. Statement 1017 | ||
|
|
| ||||
|
|
|
|
| ||
| Warning | This product requires | ||||
|
|
|
| part of the building installation. Install only in accordance with national and | ||
|
|
|
| local wiring regulations. Statement 1045 | ||
|
|
| ||||
|
|
|
|
| ||
| Warning | Hazardous voltage or energy may be present on DC power terminals. Always | ||||
|
|
|
| replace cover when terminals are not in service. Be sure uninsulated | ||
|
|
|
| conductors are not accessible when cover is in place. Statement 1075 | ||
|
|
|
| |||
|
|
|
| |||
|
| Step 1 | Prior to connecting the power supply to a power source, ensure that all of the site | |||
|
|
|
| power and grounding requirements described in Chapter 2, “Site Planning,” have | ||
|
|
|
| been met and the chassis is properly grounded as described in the “Grounding | ||
|
|
|
| Requirements” section on page | ||
|
| Step 2 | Remove the safety cover from the power terminal. | |||
|
| Step 3 | Connect the power supply ground terminal to earth ground. | |||
|
|
|
| Cisco Catalyst 4900M Switch Installation Guide |
|
|
|
|
|
|
| ||
|
|
|
| |||
|
|
|