Chapter 4 Configuring Interfaces
Configuring the POS
Examples
The following example shows output for the show interfaces pos command:
Router# show interfaces pos 1/0/0 POS1/0/0 is up, line protocol is down
Hardware is Packet Over SONET Internet address is 10.1.2.3/8
MTU 4470 bytes, BW 622000 Kbit, DLY 100 usec, rely 255/255, load 1/255 Encapsulation PPP, crc 32, loopback not set, keepalive not set Scramble enabled
LCP REQsent
Closed: CDPCP
Last input never, output never, output hang never Last clearing of "show interface" counters never Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops 5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles 0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 0 packets output, 480 bytes, 0 underruns
0 output errors, 0 applique, 5 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
The following example shows output for the show protocols pos command:
Router# show protocols pos 1/0/0
POS1/0/0 is up, line protocol is down
Internet address is 10.1.2.3/8
|
| Layer 3 Switching Software Feature and Configuration Guide |
|
|
|
|
|
| |||
|
|
|
| ||
|
|
|
|
