Cisco Systems BC-281 manual TCP/IP with RIF Passthrough Encapsulation, FST Encapsulation, BC-290

Configuring Data-Link Switching Plus

DLSw+ Configuration Task List

TCP/IP with RIF Passthrough Encapsulation

To configure TCP/IP with RIF Passthrough encapsulation, use the following command in global configuration mode:

Command	Purpose
Router(config)# dlsw remote-peer list-numbertcp	Defines a remote peer with TCP/IP with RIF Passthrough
ip-address [backup-peer[ip-address	encapsulation.
frame-relay interface serial number dlci-number
interface name]] [bytes-netbios-out
bytes-list-name][circuit-weightweight] [cost
cost] [dest-mac mac-address][dmac-output-list
access-list-number][host-netbios-out
host-list-name] [inactivity] [dynamic]
[keepalive seconds] [lf size] [linger minutes]
[lsap-output-list list] [no-llc minutes]
[passive] [priority] [rif-passthru
virtual-ring-number][tcp-queue-maxsize]
[timeout seconds]

The following command specifies a remote peer with TCP/IP with RIF Passthrough encapsulation:

dlsw remote-peer 0 tcp 10.2.23.5 rif-passthru 100

FST Encapsulation

To configure FST encapsulation on a remote peer, use the following command in global configuration mode:

Command		Purpose
Router(config)# dlsw remote-peer list-numberfst		Defines a remote peer with FST encapsulation.
ip-address [backup-peer[ip-address
frame-relay interface serial number	dlci-number
interface name]]
[bytes-netbios-out bytes-list-name]
[circuit-weight weight] [cost cost]	[dest-mac
mac-address][dmac-output-list
access-list-number][host-netbios-out
host-list-name] [keepalive seconds]	[lf size]
[linger minutes] [lsap-output-list list]

The following command specifies a DLSw remote peer with FST encapsulation:

dlsw remote-peer 0 fst 10.2.23.5

	Cisco IOS Bridging and IBM Networking Configuration Guide
BC-290	78-11737-02