Cisco Systems BC-281 manual Configuring DLSw+ Timers, BC-310

Configuring Data-Link Switching Plus

Verifying DLSw+

Configuring DLSw+ Timers

To configure DLSw+ timers, use the following command in global configuration mode:

Command	Purpose
Router(config)# dlsw timer	Configures DLSw+ timers.
{icannotreach-block-time netbios-cache-timeout
netbios-explorer-timeout netbios-group-cache
netbios-retry-interval
netbios-verify-interval sna-cache-timeout
sna-explorer-timeout sna-group-cache
sna-retry-interval sna-verify-interval}time

See the DLSw+ Design and Implementation Guide “Customization” chapter and the Cisco IOS Bridging and IBM Networking Command Reference (Volume 1 of 2) for command details.

Verifying DLSw+

To verify that DLSw+ is configured on the router, use the following command in privileged EXEC mode:

Command	Purpose
Router# show dlsw capabilities local	Displays the DLSw+ configuration of a specific peer.

The following sample shows that DLSw+ is configured on router milan:

milan#show dlsw capabilities			local
DLSw:Capabilities for peer 1.1.1.6(2065)
vendor id (OUI)	:'00C' (cisco)
version number		:1
release number		:0
init pacing window		:20
unsupported saps		:none
num of tcp sessions		:1
loop prevent support		:no
icanreach mac-exclusive		:no
icanreach netbios-excl.		:no
reachable mac addresses		:none
reachable netbios names		:none
cisco version number		:1
peer group number		:0
border peer capable		:no
peer cost		:3
biu-segment configured		:no
UDP Unicast support		:yes
local-ack configured		:yes
priority configured		:no
Cisco Internetwork Operating			System Software IOS GS Software (GS7-K-M),
Experimental Version 11.1(10956) [sbales 139]
Copyright (c) 1986-1996 by cisco Systems, Inc.
Compiled Thu 30-May-96 09:12			by sbales8

If only a command prompt appears, then DLSw+ is not configured for the router.

	Cisco IOS Bridging and IBM Networking Configuration Guide
BC-310	78-11737-02