No clns routing | Cisco Systems Cisco ASR 1006 specification

hostname Router

enable secret 5 $1$6r./$U5wHcV3uRWkKWK/fap474. enable password tests

line vty 0 4 password test no snmp-server

!

ip routing no bridge 1

no clns routing

!

interface GigabitEthernet0/0/0 shutdown

no ip address

!

interface GigabitEthernet0/0/1 shutdown

no ip address

!

interface GigabitEthernet0/0/2 shutdown

no ip address

!

interface GigabitEthernet0/0/3 shutdown

no ip address

!

interface GigabitEthernet0/1/0 shutdown

no ip address

!

interface GigabitEthernet0/1/1 shutdown

no ip address

!

interface FastEthernet0/3/0 shutdown

no ip address

!

interface FastEthernet0/3/1 shutdown

no ip address

!

interface FastEthernet0/3/2 shutdown

no ip address

!

interface FastEthernet0/3/3 shutdown

no ip address

!

interface FastEthernet0/3/4 shutdown

no ip address

!

interface FastEthernet0/3/5 shutdown

no ip address

!

interface FastEthernet0/3/6 shutdown

no ip address

!

interface FastEthernet0/3/7 shutdown

no ip address

32

Image 32

Cisco Systems Cisco ASR 1006 quick start No clns routing

Contents

Cisco ASR 1006 Router Documentation and Resources Document Revision History Prepare for Installation Prepare for Equipment Shelf or Tabletop InstallationSite Preparation and Unpacking Tools and Parts Attach the Rack-Mount Brackets-Chassis Front-Mounted Prepare for Rack-Mount InstallationRack-Mount the Router Attach the Rack-Mount Brackets-Chassis Rear Rack-Mounted Insert and tighten the black screws on one side Four-Post Rack Installation Cisco ASR 1006 Router Rear Rack-Mounting Installing the Cisco ASR 1006 Router in a Four-Post Rack Two-Post Rack Installation Installing the Cisco ASR 1006 Router in a Two-Post Rack Attach the Cable-Management Bracket 280036 Chassis Ground Connection Installation Attaching a Grounding Lug to the Chassis Ground Connector Management Ethernet Port Cable Connection Connect the Router to the NetworkConsole and Auxiliary Port Cable Connections Management Ethernet Port Connectors Connect the Shared Port Adapter Cables Start the System Install the Cables in the Cable-Management BracketConnecting AC-Input Power to the Cisco ASR 1006 Router Connect DC Power to the Cisco ASR 1006 Router Plug the power cable into the inlet Unit. Statement Installing the Cisco ASR 1006 Router DC Ground Lugs Wiring the DC-Input Power Source DC Power Supply Terminal Block 280024 280311 Verifying Power Supply Operation DC Power Supply Terminal Block and Plastic Cover Start the System Following output displays Actv Validatepackage SHA-1 hash Page Etherport Page Configure Global Parameters Using the Setup Facility Configure the RouterUsing the Console Interface OK? No clns routing Tftptimeout Page Perform Other Configuration Tasks Check the Running Configuration SettingsSave the Running Configuration to Nvram After Installation Power Off the Cisco ASR 1006 Router Replace a Power Supply in a Cisco ASR 1006 Router Remove and Then Replace an AC Power Supply Remove the DC Power Supply Unit Might One All Install and Remove the Shared Port Adapter Replace the DC Power Supply Handling a SPA Page USA