Step 4 After the SPA is properly seated, fasten the SPA in place with the captive installation screws on either side of the SPA.
Note The shared port adapter ships installed. These instructions are provided for future use. Cabling information is included with the specific shared port adapter documentation.
Step 1 Attach an ESD wrist strap between you and an unpainted chassis surface.
Step 2 If attached, remove any cables from the SPA.
Step 3 Before removing any shared port adapter, shut down the interface so that there is no traffic running through the shared port adapter when it is removed.
Note Removing a shared port adapter while traffic is flowing through the ports can cause system disruption.
Step 4 Remove the shared port adapter from the chassis slot. Unfasten the captive installation screws on either side of the SPA. Step 5 Grasp the handle and pull the shared port adapter or blank shared port adapter from the router.
Step 6 Locate the shared port adapter slot guides inside the Cisco ASR 1006 Router. They are near the top, and are recessed about
Caution The shared port adapter must slide into the slot guides under the chassis lid. Do not allow the shared port adapter
components to come in contact with the system board or the shared port adapter could be damaged.
Step 7 Carefully slide the shared port adapter into the shared port adapter slot and seat it. When installed, the shared port adapter input/output panel should be flush with the face of the router.
Step 8 Reconnect any cables, including the shared port adapter and power cables, and place the cables through any
Note If the shared port adapter fails to come up, reseat or reinsert the shared port adapter: do not use excessive force.
Step 9 Power on the router by turning the power switch to the On() position.
Note For detailed Cisco SPA and SIP information, see the Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide.
42
