Step 2 Plug the power cable into the inlet.
Note For additional AC power cable strain relief, secure the cable to the power supply handle by inserting a nylon cable tie through the hole in the handle and around the cable.
Figure 10 Cisco ASR 1006 Series Router AC Power Supply
5
4
6 | 7 | 8 |
| OUTPUT INPUT INPUT | |
| FAIL | OK OK |
ALARMS 
60V 
1A MAX
100-240V~ 16-7A
50-60HZ
This unit might have more than one power supply connection. All connections must be removed to
280029
| 3 |
| 2 | 1 |
|
|
|
|
|
1 | AC power supply fan | 5 | AC power supply handle |
|
|
|
|
|
|
2 | 6 | AC power inlet |
| |
|
|
|
| |
3 | 7 | AC power supply Standby switch | ||
|
|
|
|
|
4 | AC power supply captive screw | 8 | AC power supply LEDs |
|
|
|
|
|
|
Step 3 Plug the AC power supply cable into the AC power source at your site.
Step 4 Place the power supply Standby switch in the On (I) position.
This completes the procedure for connecting
Connect DC Power to the Cisco ASR 1006 Router
This section provides instructions for installing the DC power supply into the Cisco ASR 1006 Router. Read the safety warnings before you begin.
Warning
Warning
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Never install an AC power module and a DC power module in the same chassis. Statement 1050
When installing or replacing the unit, the ground connection must always be made first and disconnected last. Statement 1046
16
