Cisco Systems CIVIS-IPC-2611 manual Preparing for Installation

Chapter 2 Getting Started

Installing the Cisco Video Surveillance 2611 IP Dome

Preparing for Installation

Before you install the 2611 IP dome, take these actions:

•Carefully unpack the IP dome and its components.

•Run an category 5 or higher network cable to the mounting location.

•If the IP dome will not be powered from POE, run a power cable from a 12 VDC or 24 VAC power adapter to the mounting location.

Use a cable gauge that is appropriate for the distance from the IP dome to the power supply (consult a qualified electrician for more information). The terminal connectors on the IP dome support gauges from 14 AWG to 24 AWG. At the end of the wire that attaches to the IP dome, strip enough cable housing to allow each wire to be stripped to 1/4 inch (6.25 mm).

•If you will connect an external speaker, microphone, or both to the IP dome, run audio cable from each device to the mounting location.

To attach the audio cable to the IP dome, you will need the white snap on ferrite core and audio Y cable that are included in the optional audio/video cables accessory kit, which you can purchase from Cisco (Cisco part number CIVS-IPCA-1017=). Attach the white snap on ferrite core to the audio Y cable (from the optional accessory kit) at approximately 10 inches (25 cm) away from where the cable connects to the IP dome. To do so, lift the tabs to open the ferrite core, pass the cable through the ferrite core (do not loop the cable), then snap the ferrite core shut to secure it on the cable. See Figure 2-1.

Figure 2-1 Passing the Audio Cable through a Ferrite Core

•If you will use external input devices or output device that trigger alarms (connect through alarm input ports) or respond to alarms (connect through alarm output ports), run cables from each device to the mounting location. You can use up to two input devices and up to two output devices.

•Have an analog monitor available on which to view video while adjusting the field of view.

Caution Use the analog monitor only to point the IP camera to the desired field of view; do not use it to manually adjust the focus or zoom. Doing so may damage the lens. Instead, use the Focus/Zoom window in the configuration software to remotely set the focus and zoom for the IP camera.

•Have the following tools available:

–Phillips-head screwdriver

–Small flat-head screwdriver

–Cutting tool to cut a hole in a ceiling tile (required for mounting in a ceiling tile)

–Drill bits (required for surface mounting on a solid surface)

Cisco Video Surveillance 2611 IP Dome User Guide

OL-24128-02 2-3