Chapter 2 Getting Started
Powering the IP Camera On or Off
Figure 2-4 Adjusting the Camera Lens on the 2611 IP Dome
1
2
1Rotation wheel
2Panning lock screw
3Tilt lock screws (2)
4Back focus hex screws (3)
3
4
Step 4 Remove the analog monitor cable from the analog video output port.
Step 5 Replace the privacy shield by squeezing it to fit inside the four tabs on the camera unit.
Make sure to adjust the privacy shield inside the dome and trim ring assembly so that it does not block the lens from capturing video.
Step 6 Replace the IP dome assembly by positioning the open end of the hooks on the IP dome assembly toward the steel pegs on the camera unit, lifting it into onto the camera unit, and twisting it clockwise.
Powering the IP Camera On or Off
The IP camera does not include an on/off switch. You power it on or off by connecting it to or disconnecting it from a power source. When you power off the IP camera, it retains configuration information.
To power on the IP camera, take either of these actions:
•Use an category 5 or higher network cable to connect the IP camera to a network switch that provides 802.3af compliant PoE
•Use the appropriate power adapter to connect the IP camera to a wall outlet
|
| Cisco Video Surveillance 2611 IP Dome User Guide |
|
| |
|
|
| |||
|
|
|
| ||
|
|
|
| ||
