Cisco Systems CIVIS-IPC-2611 manual Recessed Mounting in a Ceiling Tile, Procedure

Chapter 2 Getting Started

Installing the Cisco Video Surveillance 2611 IP Dome

Recessed Mounting in a Ceiling Tile

You can recess-mount the IP dome in a ceiling tile. With this method, the bottom edge of the IP dome housing is flush with a ceiling. The ceiling tile must be able to support at least three times the weight of the IP dome. An optional ceiling tile mount is available to reinforce a ceiling tile so that the tile provides adequate support. You can purchase the ceiling tile mount from Cisco (Cisco part number CIVS-IPCA-1008=).

To recess-mount the IP dome, perform the following steps. Make sure that the location in which you install the IP dome can support at least three times the weight of the IP dome.

Note When you disassemble the IP dome for mounting as described in these steps, make sure to remove any protective packing material that is installed between components.

Procedure

Step 1 Remove the dome and trim ring assembly from the camera housing by turning the assembly counter-clockwise (see Figure 2-2).

Step 2 Remove the Privacy shield by squeezing it inward to release it from the four tabs that hold it into place (see Figure 2-2).

Step 3 Remove the camera unit from the camera housing by using a Phillips-head screwdriver to unscrew the two camera unit screws (see Figure 2-2).

Figure 2-2 Disassembling the 2611 IP Dome Components

1

2

3

4

5

Cisco Video Surveillance 2611 IP Dome User Guide

2-4 OL-24128-02