Cisco Systems IGX 8400 Series manual Observe that the ACTIVE LED on the ARM card is on

Making Frame Relay Connections

Step 2 From a control terminal or a Cisco WAN Manager NMS workstation, to the node and enter the addalmslot command followed by the slot number where the ARM is located. This will activate the alarm reporting from the card.

Step 3 Observe that the ACTIVE LED on the ARM card is on.

Step 4 Testing the operation of the alarm outputs requires you to create an alarm and note the resulting alarm output. This test is easy on a node that is not connected to the network but difficult on a node in a fully operational network. The best time to create a major alarm an operational network is during a low traffic period. If you create an alarm, go to Step 5. Otherwise, stop here.

Step 5 Create an alarm by disconnecting a trunk cable from the connector on a back card.

Step 6 Observe that a lit MAJOR LED appears on the front of the ARM.

Step 7 Using a voltage/ohm meter (VOM), make sure continuity exists between pins 16 and 17 and between pins 35 and 36 at the DB-37 connector on the ARI card.

Step 8 Reconnect the cable that was disconnected in Step 5.

Step 9 With the VOM, check that the reading between pins 16 and 17 and pins 35 and 36 are open and the MAJOR LED is not on.

Alarm output connections are made at the DB37 connector on the ARI card. The connector pin assignments with the alarm signal names are listed in Table 3-1.(See Appendix C, “Cabling Summary.”)

Table 3-1	ARI Alarm Connector PinOuts
Pin No.	Alarm Type	Alarm Name	Alarm Description
1	both	CHASSIS	Protective ground
3	Network	NWMAJA	Major—normally open contact
22	Network		Major—normally closed contact
4	Network	NWMAJC	Major—common contact
10	Node	MNVISA	Minor Visual—normally open contact
11	Node		Minor Visual—normally closed contact
12	Node	MNVISC	Minor Visual—common contact
16	Node	MJAUDC	Major Audible—common contact
17	Node	MJAUDA	Major Audible—normally open contact
23	Network	NWMINA	Minor—normally open contact
24	Network		Minor—normally closed contact
25	Network	NWMINC	Minor—common contact
29	Node	NWAUDA	Minor Audible—normally open contact
30	Node		Minor Audible—normally closed contact
31	Node	NWAUDC	Minor Audible—common contact
35	Node	MJVISC	Major Visual—common contact
36	Node	MJVISA	Major Visual—normally open contact

3-36Cisco IGX 8400 Series Installation and Configuration