Cisco Systems IGX 8400 Series manual Making Serial Data Connections, 11 SDI and LDI Faceplates

Making Serial Data Connections

Making Serial Data Connections

The low-speed data module (LDM) and high-speed data module (HDM) card sets provide serial data service. Each of these front cards uses a variety of back cards.

The LDM front card uses the 4-port or 8-port version of the low-speed data interface (LDI) back card for EIA/TIA-232C/D (V.24) connections. The connection ports are labeled PORT 1 through PORT 4 or PORT 1 through PORT 8. See Figure 3-11for illustrations these back cards. For instructions on configuring an LDI port for DTE or DCE mode, refer to the section Configuring the Mode of an LDI Port “Configuring the Mode of an LDI Port on page 26.”

The HDM front card works with four types of serial data interface (SDI) back cards. SDIs are available. These are V.35, EIA/TIA-449/422, EIA/TIA-232D, and EIA/TIA-232C (V.24). (X.21 uses EIA/TIA-449 plus an adapter cable.) Each type of SDI has four connection ports, which are labeled PORT 1 through PORT 4. An example SDI card appears in Figure 3-11.

When you connect an HDM or LDM port, use the shortest reasonable cable length for each port.

Figure 3-11 SDI and LDI Faceplates

SDI

Port 1

Port 2

Port 3

Port 4

xxxxxx

xxxx xxx

xxxxxx

xxx xxxx

x xx

xx xx xx

LDI

xxxxxx

xxxxxx

xxx xxxx

x xx

xx xx xx

LDI

Port 1

Port 2

Port 3

Port 4

Port 5

Port 6

Port 7

Port 8

xxxxxx

xxxxxx

xxx xxxx

x xx

xx xx xx

SDI	LDI 4 Port	LDI 8 Port
(V.35 shown)

H8355

3-24Cisco IGX 8400 Series Installation and Configuration