7. CAUTIONS ON WIRING
English INSTALLATION MANUAL
1.Be sure to turn the power off before wiring.
2.Be particularly careful where you route the wires.
Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.
3.If the fuse should blow, check to see if the wiring is correct.
If a fuse is blown, replace it with a new one of the same amperage rating as the original (15A FUSE).
4.To replace the fuse, remove the old fuse of the power supply cord and insert the new one. (Figure 8)
Note:
•There are various types of fuse holder. Do not let the battery side touch other metal parts.
caution
CAUTION
After the connection, fix the cord by a clamp or insulation tape for protection.
Fuse (15A FUSE)
Fuse holder 
5.Connect the CeNET extension cable fully and securely until it locks. When the CeNET extension cable is pulled, hold the slide cap part and pull it towards you. (Figure 9)
•When you want to extend the CeNET cable, use extension cable
CeNET terminal
Slide cap
CeNET cable (provided with the Navigation System)
Figure 9
Figure 8
