Chapter 3. Quick Setup

8. Enable Recording

Step 3. Globally configure all cameras to record by clicking on “All” mark to enable all cameras then set resolution to desired setting.

Make sure that All is Unchecked.

Set resolution either to 360X240 ~ 720X480

Step 4. Choose fps setting globally and do not exceed base fps. In the picture example is 480fps as base fps.

Maximum fps cannot exceed 480 fps in this example.

This section will impact total fps for continuous.

This section will impact total fps for event driven.

Step 5. Chose picture quality setting.

Picture Quality setting for continuous

Picture Quality setting for event drive

Step 6. Exit and confirm changes.

Page 50

Page 50
Image 50
Clover Electronics DV1670D instruction manual Enable Recording