Chapter 9. Systems Section
2. DISK MANAGER GUI
Figure 62 HDD Installation
When you mount a single hard drive, mount it to “Master HDD” as described in the picture above and connect the power. Then, connect the SATA cable to the main board “HDD1.”
When you’d like to mount two HDDs, install “Slave HDD” as described in the picture above, connect the power. And then, connect SATA cable to the main board “HDD2.”
Installing ODD (Optical Disk Drive)
Alternatively you may have HDD 1 and Optical Disk Drive.
Important reminder is to make sure after inserting ODD, check to see recording in HDD 2 is not enabled and make sure that ODD is visible in disk manager section..
Page 74
