Chapter 2
STX F - Form Feed
This commands the printer to form feed one label.
STX G - Print Last Label Format
This command prints a previously formatted label and restarts a canceled batch job after the last processed label. This is used when there is a label format in the print buffer. The <STX>E command is used to enter the quantity.
STX I - Input Image Data
This command must precede image data downloading from a host computer to the printer. The data that immediately follows the command string will be image data.
STX i - Downloading Scalable Fonts
The command structure for downloading TrueType (.TTF) scalable fonts follows, (font files must be single character systems).
STX K - Extended-System Commands
This expands the
STX KE - Character Encoding
This command specifies a character in the DPL datastream to be substituted with a delimited
Any character in the DPL datastream may be substituted with a delimited two- character ASCII hexadecimal numeric equivalent. The command allows the delimiting character to be selected, and the encoding to be enabled or disabled. When character encoding is enabled, the printer will decode any ASCII hexadecimal numeric pairs following the delimiter as single byte values. This command is used where control characters cannot be transmitted or where control characters within data may prematurely terminate a label format record. Although the delimiter may be changed at any time (except within a label format definition) there cannot be more than one defined delimiter, and character encoding must be disabled with <STX>KN prior to
STX k - Test RS-232 Port
This command instructs the printer to transmit the character Y from the printer’s
STX L - Enter Label-Formatting Command
This command switches the printer to the
18
