Table of Contents
1 | Introduction | 11 |
| About This Manual | 11 |
| Coax/Twinax Interface Requirements | 11 |
| PPI/DGL SETUP Menu | 12 |
| PPI/DGL SETUP Submenu | 13 |
| Active | 13 |
| Character Set | 13 |
| Euro Character | 14 |
| Control Codes | 14 |
| Feedback Chars | 14 |
| Default Module | 14 |
| Units of Measure | 14 |
| Row Offset | 15 |
| Column Offset | 15 |
| Format Attrib | 15 |
| Error Handling | 15 |
| Vertical DPI Adjust | 16 |
| Command Ignore Menus | 16 |
| Length Cmd (STXc) | 16 |
| Heat Cmd (H) | 16 |
| Speed CMD (P,S) | 16 |
| Cut Cmd (o,:,c) | 16 |
| Soft Switch (V) | 16 |
| Sensor Cmd (e,r) | 16 |
| Format Attr.(A) | 16 |
2 | Fully Supported Commands | 17 |
| 17 | |
| STX A - Set Time and Date | 17 |
| STX a - Enable Feedback Characters | 17 |
| STX B - Get Printer Time and Date Information | 17 |
| STX c - Set Continuous Paper Length | 17 |
| STX E - Set Quantity For Stored Label | 17 |
| STX e - Select Edge Sensor | 17 |
| STX F - Form Feed | 18 |
| STX G - Print Last Label Format | 18 |
