Dell 2710 owner manual Replacing the Infrared-Emitter Port

49 Replacing the Infrared-Emitter Port

WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in "Before You Begin" on page 11. After working inside your computer, follow the instructions in "After Working Inside Your Computer" on page 13. For additional safety best practices information, see the Regulatory Compliance Homepage at dell.com/ regulatory_compliance.

Procedure

1Slide the infrared-emitter port through the slot on the I/O-board bracket.

2Replace the nut that secures the infrared-emitter port to the I/O-board bracket.

Postrequisites

1Follow step 3 to step 7 in "Replacing the I/O Board" on page 101.

2Replace the inner frame. See "Replacing the Inner Frame" on page 97.

3Replace the system-board shield. See "Replacing the System-Board Shield" on page 33.

4Replace the I/O panel. See "Replacing the I/O Panel" on page 93.

5Replace the trim cover. See "Replacing the Trim Cover" on page 89.

6Replace the stand. See "Replacing the Stand" on page 49.

7Replace the back cover. See "Replacing the Back Cover" on page 21.

Replacing the Infrared-Emitter Port 109