Dell 610 manual Ljxuh

￿￿,QVHUWWKHH[SDQVLRQFDUGLQWRWKHH[SDQVLRQ￿FDUGFRQQHFWRU￿

If the expansion card is full-length, insert the front end of the card into the corre- sponding card guide on the inside front of the chassis as you insert the card into its connector.

Insert the card’s edge connector firmly into the expansion-card slot. Gently rock the card into the connector until it is fully seated (see Figure 9-4).

expansion card	expansion-card
	connector

	)LJXUH	VHFXUHWKHconnectorFDUG￿V
	:KHQPRXWLQJEUDFNHWWRWKHFKDVVLVZLWKWKHVFUHZ\RXUHPRYHGLQVWHS￿￿
￿￿		card-edge
	&RQQHFWDQ\FDEOHVWKDWVKRXOGEHDWWDFKHGWRWKHFDUG￿

See the documentation that came with the card for information about the card’s

￿￿HUDOV5HSODFHcable connectionsWRWKHLUFRPSXWHUSRZHU. VRXUFFRYUHV￿DQGWXUQUHFRQQHFWWKHPRQ\RXU￿FRPSXWHUDQGSHULSK￿

NOTE: After you remove and replace the cover, the chassis intrusion detector will cause the following message to be displayed at the next system start-up:

￿￿DQG7RALERT!UHVHWUHVHWWKHCover&KDVVLFKDVLVwasV,QWUXVLRQLQWUXVLRQpreviouslyWRGHWHFWRU1RWremoved'HWHFWHG￿HQWHU. ￿WKH6\VWHP6HWXSSURJUDP

See Chapter 3, “Using the System Setup Program,” for instructions.

NOTE: If a setup password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion detector.

Installing System Board Options 9-5