Dell 610 manual ISA Configuration Utility Messages C-5

7DEOH0HVVDJH&￿￿￿&RQILJXUDWLRQ8WLOLW\3UREDEOH0HVVDJHV&DXVH￿FRQWLQXHG￿ &RUUHFWLYH$FWLRQ

The configuration (.cfg) file used by the ICU for this card is now invalid or does not exist. Do you wish to load the file?

No configuration (.cfg) file exists for the card being modified. Do you want to load one?

This message appears when you try to add a listed card and the configuration file for this card has been corrupted or deleted from the database.

This message appears when you modify a card and its configuration file does not exist or has been deleted.

You can get a copy of the configuration file from the original ISA Configuration Utility Diskette that you used to create the backup ICU diskette. Use the fol-

￿￿￿￿lowingFDUGLFX8VHRQ&KDQJHGULYHUDWLRQ,QVHUWWKHRULJLQDOprocedure:￿WKHQG[\RX$WH[WGLVNWW8WLOLW\'LVNHWWHILOH￿WRZDQWIRUHGLWKHWKHRGLYHUEDGGFDUGWRVXEGLUHFWRU\,6￿VHDUFKRU$LQWR,'&RQILJXPRGLI\RIWKH￿￿

The name of the configuration file is part of this card ID. For example, if the card ID is ICU0200, the con-

￿￿WRIURPW&S\figurationWKHKHEDFNXSfileRULJLQDOFRQILJXUDWLRQis !icu0200GLVNHWWH,&8.GLVNHWWHcfg￿ILOH.

This is an EISA system. Use an ECU, not the ICU, to configure your system.

This message appears if you attempt to run the ICU on an EISA system.

To use the ICU, you must load the utility onto a non-EISA system.

NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary.

ISA Configuration Utility Messages C-5