Dell 610 manual See Modifying a Card in for instructions

7DEOH0HVVDJH&￿￿￿&RQILJXUDWLRQ0DQDJHU3UREDEOH0HVDJHV&DXVH ￿FRQWLQXHG&RUUHFWLYH￿ $FWLRQ

WARNING: Could not configure Plug and Play Card Name.

WARNING: Could not configure PCI device, ID=DeviceID.

Failed to configure Number of Total Count Plug and Play ISA devices. Use your system’s configura- tion utility to resolve conflicts. Press any key to continue.

The card(s) mentioned are not fully configured due to resource conflicts.

If you have documentation that lists the allow- able resource values for your Plug and Play or PCI expansion card, you can use the following procedure to locate and resolve the resource conflict.

NOTE: If you do not have documentation list- ing the allowable resource values, see the corrective action for these messages on the following￿￿6WDUWWKH,&8page. ￿

Any Plug and Play or PCI expansion cards that could not be configured should be marked config err in the list of cards

￿￿IURP6HOHFWin theWKHICUWKH9LHZwindow6\VWHPPHQX. 5HVRXUFHVRSWLRQ￿

The System esource Usage dialog box displays all resources currently used by

￿￿EXWWRQFDUG\RXU6HOHFWthe system￿3OXJDQGDQGRQH￿.FOLFNRIWKH3OD\RU3&,WKHUHVRXUFHVXVHG8VHG%\H[SQVLRQ&DUGE\

The Card esources Usage dialog box identifies which device is using the

￿￿￿￿5SHDWILFDU0RWKHXQFRILJXUHG3OXJH[SDresourceHGGUHVRXUFHVDOOLI\WKHQWKDWVLRQFRQIOLFWLQJVWHS. XVHFDUGFDUGV￿UHTXLUHGXQWLOWKHP￿DVUHVRXUFHVDQ\RX￿HHGHGE\3OD\RU3&,KDYHWKHDQGWRLGHQWLIUHHWKH￿

See “Modifying a Card” in Chapter 4 for instructions.

NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary.

ISA Configuration Utility Messages C-9