
A jumper is referred to as open or unjumpered when the plug is pushed down over only one pin or if there is no plug at all. When the plug is pushed down over two pins, the jumper is referred to as jumpered. The jumper setting is often shown in text as two numbers, such as
Figure B-1 shows the location and default settings of the jumper blocks on your sys- tem board. See Table B-1 for the designations, default settings, and functions of your system’s jumpers.
6ZLWFKHV
Switches control various circuits or functions in your computer system. The switches you are most likely to encounter are dual
slide switches | rocker switches |
Each of these switches has two positions, or settings (usually on and off). To change the setting of a slide switch, use a small, pointed object such as a small screwdriver or a straightened paper clip to slide the switch to the proper position. To change the setting of a rocker switch, use the screwdriver or paper clip to press down on the appropriate side of the switch. In either case, do not use a pen, pencil, or other object that might leave a residue on the switch.