Figure 25. PowerConnect M6220 Ethernet Switch I/O Module

1.optional modules (2) (dual 10 Gb Ethernet uplink module shown)

2.standard 10/100/1000 Mb Ethernet connectors (4)

3.serial connector (USB type-A form factor)

4.power indicator

5.status/identification indicator

Dell PowerConnect M8024 10 Gb Ethernet Switch I/O Module

The PowerConnect M8024 switch module incorporates two optional bays that support the following modules:

A 10 Gb Ethernet module with four optical SFP+ connectors

A 10 Gb Ethernet module with three copper CX4 uplinks

A 10 Gb Ethernet module with two copper 10GBASE-T uplinks

The modules can be used in any combination and are sold separately.

You can initially configure the switch using either of two methods:

Connect an external management system to the switch using an optional USB type-A form factor serial cable, and configure the switch using a terminal application.

Use the iKVM CMC console (“17th blade”) and the connect switch-nCMC CLI command. For more information, see the CMC User’s Guide at support.dell.com/manuals.

Once an IP address is assigned to the management VLAN or interface and the switch is connected to a management network, both Telnet and http are available through the network.

59

Page 59
Image 59
Dell BMX01 Dell PowerConnect M8024 10 Gb Ethernet Switch I/O Module, PowerConnect M6220 Ethernet Switch I/O Module