Back to Contents Page

Adding and Replacing Parts

Dell™ Latitude™ D420 User's Guide

Before You Begin

Keyboard

Hard Drive

Memory

Removing the Hard Drive

Mini-Cards

Dismantling the Hard Drive

Subscriber Identity Module (SIM) Card

Replacing the Hard Drive

Internal Card With Bluetooth® Wireless T

Hinge Cover

Coin-Cell Battery

 

 

 

Before You Begin

This chapter provides procedures for removing and installing the components in your computer. Unless otherwise noted, each procedure assumes that the following conditions exist:

You have performed the steps in Turning Off Your Computer and Before Working Inside Your Computer.

You have read the safety information in your Dell™ Product Information Guide.

Recommended Tools

The procedures in this document may require the following tools:

Small flat-blade screwdriver

Phillips screwdriver

Small plastic scribe

Flash BIOS update (see the Dell Support website at support.dell.com)

Turning Off Your Computer

NOTICE: To avoid losing data, save and close any open files and exit any open programs before you turn off your computer.

1.Shut down the operating system:

a.Save and close any open files, exit any open programs, click StartShut Down.

b.Select Shut downOK.

The computer turns off after the operating system shutdown process finishes.

2.Ensure that the computer and any attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut down your operating system, press and hold the power button for 4 seconds.

Before Working Inside Your Computer

Use the following safety guidelines to help protect your computer from potential damage and to help ensure your own personal safety.

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

CAUTION: Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges or by its metal mounting bracket. Hold a component such as a processor by its edges, not by its pins.

NOTICE: Damage due to servicing that is not authorized by Dell is not covered by your warranty.

NOTICE: When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables have a connector with locking tabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keep them evenly aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented and aligned.

NOTICE: To prevent damage to the computer, perform the following steps before you begin working inside the computer.

1.Ensure that the work surface is flat and clean to prevent the computer cover from being scratched.

2.Turn off your computer (see Turning Off Your Computer).

Page 51
Image 51
Dell D420 specifications Adding and Replacing Parts, Before You Begin, Recommended Tools, Turning Off Your Computer