Dell D420 specifications Dell Diagnostics Main Menu, Option Function

The computer runs the Pre-boot System Assessment, a series of initial tests of your system board, keyboard, hard drive, and display.

•During the assessment, answer any questions that appear.

•If a failure is detected, the computer stops and beeps. To stop the assessment and restart the computer, press <Esc>; to continue to the next test, press <y>; to retest the component that failed, press <r>.

•If failures are detected during the Pre-boot System Assessment, write down the error code(s) and contact Dell (see Contacting Dell).

If the Pre-boot System Assessment completes successfully, you receive the message Booting Dell Diagnostic Utility Partition. Press any key to continue.

5.Press any key to start the Dell Diagnostics from the diagnostics utility partition on your hard drive.

Starting the Dell Diagnostics From the Optional Drivers and Utilities CD

NOTE: You must have the Latitude D420 Media Base in order to perform the steps below.

1.Insert the Drivers and Utilities CD.

2.Shut down and restart the computer.

When the DELL logo appears, press <F12> immediately.

If you wait too long and the Windows logo appears, continue to wait until you see the Windows desktop. Then shut down your computer and try again.

NOTE: The next steps change the boot sequence for one time only. On the next start-up, the computer boots according to the devices specified in the system setup program.

3.When the boot device list appears, highlight CD/DVD/CD-RW Drive and press <Enter>.

4.Select the Boot from CD-ROMoption from the menu that appears and press <Enter>.

5.Type 1 to start the menu and press <Enter> to proceed.

6.Select Run the 32 Bit Dell Diagnostics from the numbered list. If multiple versions are listed, select the version appropriate for your computer.

7.When the Dell Diagnostics Main Menu appears, select the test that you want to run.

Dell Diagnostics Main Menu

1. After the Dell Diagnostics loads and the Main Menu screen appears, click the button for the option that you want.

Option	Function
Express Test	Performs a quick test of devices. The test typically takes 10 to 20 minutes and requires no interaction on your part. Run Express Test first to
	increase the possibility of tracing the problem quickly.
Extended	Performs a thorough check of devices. The test typically takes 1 hour or more and requires you to answer questions periodically
Test
Custom Test	Tests a specific device. You can customize the tests you want to run.
Symptom	Lists the most common symptoms encountered and allows you to select a test based on the symptom of the problem you are having.
Tree

2.If a problem is encountered during a test, a message appears with an error code and a description of the problem. Write down the error code and problem description and follow the instructions on the screen.

If you cannot resolve the error condition, contact Dell (see Contacting Dell).

NOTE: The Service Tag for your computer is located at the top of each test screen. If you contact Dell, technical support will ask for your Service Tag.

3. If you run a test from the Custom Test or Symptom Tree option, click the applicable tab described in the following table for more information.

Tab	Function
Results	Displays the results of the test and any error conditions encountered.