w w w . d e l l . c o m s u p p o r t . d e l l . c o m

12To verify that the memory is installed correctly, check the amount of memory (RAM) listed.

Adding or Replacing the AGP Card

CAUTION: Before you begin any of the procedures in this section,

follow the steps in "When Working Inside Your Computer" on page 12.

CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.

Your Dell™ computer provides a connector for an AGP card.

1Shut down the computer (see page 33).

NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.

2Turn off any attached devices and disconnect them from their electrical outlets.

3Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.

4Open the computer cover (see page 84).

Removing an AGP Card

1Remove the filler bracket by raising the hinged lever and sliding the bracket up.

2Press the card lever toward the PCI connector.

98

Adding Parts

Page 98
Image 98
Dell DHM, K0004 manual Adding or Replacing the AGP Card, Removing an AGP Card