w w w . d e l l . c o m s u p p o r t . d e l l . c o m

12Connect a power cable to the drive.

NOTICE: Match the colored strip on the cable with pin 1 on the drive.

13Locate the extra connector on the drive cable that is attached to your first hard drive and attach the connector to the second hard drive.

Your computer uses cable-select drive cables. This means that the device connected to the end connector of the drive cable is the master device and the device connected to the middle connector is the slave device. Be sure that the jumper setting on the new device is set for "cable select" (see the documentation that came with the drive for information).

power cable

second hard-drive cable (secondary drive)

first hard-drive cable (primary boot drive)

14Close the computer cover.

NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

15Connect your computer and devices to electrical outlets, and turn them on.

102

Adding Parts

Page 102
Image 102
Dell DHM, K0004 manual Power cable, 102