Power

Menu

POWER ON IP LAST

Spectrum Analyzer Mode Key Descriptions

Spectrum Analyzer Mode Functions

accesses functions which make transmitter power measurements. The measurements are designed for analog radio or continuous carrier digital radio signals.

If another front-panel key is pressed, exiting the power menus, press the [w) key twice to return to the last power menu that was being used.

Front-Panel Key Access (a)

determines the state of the analyzer when the analyzer is powered on. If the POWER ON function is set to IP, the state of the analyzer is the same as it is after (PRESET) is pressed, when the analyzer is powered on. If the POWER ON function is set to LAST, then the state that the analyzer was left in when it was powered off is recalled.

The setting (IP or LAST) of the POWER ON function is not changed by pressing (PRESET). Use the POWER ON IP LAST softkey function to change the setting of the analyzer state which is recalled at power on. Limit lines are not recalled when the analyzer is powered up.

N O T E

If you have a downloadable program or “personality” installed in analyzer memory, the following changes apply to the operation of the POWER ON function: When using a downloadable program or personality, the last state of the personality is not recalled. We recommend that if you are using a downloadable program or personality, you set POWER OM IP LAST to II? If

POWER ON IP LAST is set to LAST, you must press C-1 whenever you power on the analyzer.

Front-Panel Key Access (CONFIG)

6-111