Using Spectrum Analyzer Features
Saving and Recalling Data from Analyzer Memory
To Save a Limit-Line Table or Amplitude Correction Factors
The procedure for saving limit-line tables or amplitude correction factors is similar to saving trace data. State and trace data is not recalled with limit-line tables or amplitude-correction factors.
1. Enter a screen title, if desired, by using (j’, Change Title . The
screen title is displayed when CATALOG REGISTER is used to catalog the trace registers. The screen title is not recalled, however, with the limit-line tables or amplitude correction factors.
2.When saving limit-line tables, set up the limit-line table to be stored (see “Using the Limit-Line Functions” in this chapter). When saving amplitude correction factors, enter the data using the remote programming AMPCOR command or use the amplitude-correction function softkeys. See “Using Amplitude Correction Functions” in this chapter for more information about entering amplitude correction factors via the front-panel.
3.Press m. If CARD is underlined, press INTERNAL CARD to select
INTERNAL.
4.Press Trace + Intrril This accesses a menu with LIMIT LINES and
AMP CDR.
5.Press LIMIT LINES to save limit-line tables. Press AMP COR to save amplitude-correction factors. REGISTER # and MAX REG # = are displayed on the cable TV analyzer screen. The number after MAX REG # = indicates the maximum register number that can be entered for storage in cable TV analyzer memory.
6.Use the numeric keypad to enter a number from 0 to the maximum register number and then press (ENTER).