Using Spectrum Analyzer Features

learn How to Enter Amplitude Correction Factors

Selecting the Frequency Press SELECT FREQ , then enter a frequency value for the point. Coordinate

N O T E

Only two entries per frequency are used. If more points with the same frequency are entered, only the first and last entries are used. All other amplitude values are ignored. See Figure 3-13 for an example of two entries at the same frequenn/.

N O T E

When entering amplitude-correction data, the frequency and amplitude values will be listed as asterisks (***I until new values are entered. Once the frequency value is entered, the segment is immediately sorted into the table according to this value.

Selecting the Amplitude The amplitude value is entered by pressing SELECT AMPLITUD , entering an

Coordinateamplitude value, and pressing a units key.

N O T E

Frequency or amplitude values that are not within range will be modified. For example, a frequency value of 3 GHz will be modified to 1.9 GHz.

3-63