SRC PWR ON OFF

SRC PWR STP SIZE

START

F=Q

STATE + CARD

Spectrum Analyzer Mode Key Descriptions

Spectrum Analyzer Mode Functions

Option 011 only.

activates (ON) or deactivates (OFF) the output power of the tracking generator (SRC). The power level can then be adjusted using the data keys, step keys, or knob. Pressing any digit, 0 through 9, on the numeric keypad brings up the selected terminator menu. The available output power level varies for different analyzer models. See specifications and characteristics in your calibration guide for specific information for your analyzer.

Front-Panel Key Access IJiZ5Z~

Option 011 only.

allows the user to set the step size of the source-power level, source-power offset, and power-sweep range functions. The step size may be values from -32.7 dB to 32.7 dB. The default setting is one vertical scale division.

Front-Panel Key Access (AUX]

sets the frequency at the left side of the graticule. The left and right sides of the graticule correspond to the start and stop frequencies. When these frequencies are activated, their values are displayed below the graticule in place of center frequency and span.

Front-Panel Key Access ( F R E Q U E N C Y )

saves the current analyzer state on the memory card. To save the current state, press STATE -+ CARD , use the

numeric keypad to enter a number, and press ENTER If you want the file name of the stored data to contain a prefix, press Change Prefix to enter a prefix before storing the data. If the state data was stored using a prefix, the hle name for the state data consists of s(prefix)-(register number). If no prefix was specified, the hle name is s-(register number). If windows are being used, only the state of the active window will be saved.

Front-Panel Key Access m

6-137