Saving and Recalling Data from Analyzer Memory

This section explains how to save and recall state, trace, limit line, and amplitude correction factor data to and from cable TV analyzer memory. You can use STATE 4 INTRNL to store up to eight states in analyzer

memory, and Trace + Intrnl to store many traces, limit-line tables, and amplitude-correction factors.

Saving state data saves the cable TV analyzer settings, but not the trace data. Saving trace data saves the trace data and the state data. Limit-line data and amplitude correction factors are stored in trace registers, but state and trace data are not recalled with the limit-line data or the amplitude correction factors. States, traces, limit-line tables, and amplitude correction factors are saved in cable TV analvzer memorv even if the instrument is turned off or

(M)is pressed.

Refer to the Catalog Internal softkey description in Chapter 6 for more information about cataloging cable TV analyzer memory.

Refer to Table 3-l at the end of this section for a summary of saving and recalling data to and from cable TV analyzer memory.

To Save a State

1.Set up the cable TV analyzer settings to be saved

3.Press m). If CARD is underlined, press INTERNAL CARD to select INTERNAL. Selecting INTERNAL selects the cable TV analyzer memory as the mass storage device.

3.Press STATE + INTRNL SAVE: REG is displayed on the cable TV analyzer display.

4.Enter a number from one to eight using the numeric keypad and the state is saved automatically.

3-8