Using Spectrum Analyzer Features

learn How to Enter Amplitude Correction Factors

Procedure for Creating Amplitude-Correction Factors

This procedure demonstrates how to create and activate amplitude-correction data. Detailed descriptions of the amplitude-correction functions follow this procedure.

1.Press (jPRESET).

N O T E

A signal is not used in this procedure for demonstrating how to create amplitude-correction data Disconnect any cable on the cable TV analyzer input.

2.Set the center frequency to 300 MHz and the span to 500 MHz by pressing:

3.Press [CAL), More 1 of 4 , More 2 of 4 , More 3 of 4, then

Amp Cor to access the amplitude-correction menus.

4.Press Edit Amp Cor to access the editing menus for

amplitude-correction factors.

5.To clear any existing amplitude-correction data, press PURGE AMP COR two times consecutively.

3 - 5 8