Using Spectrum Analyzer Features
Use the Peak Table to List the Displayed Signals
Example: Use the peak table function to measure the calibrator signal and its harmonics.
1.Connect the CAL OUT signal to the cable TV analyzer’s INPUT 75 D and press [GZGY).
2.Press [PEAK SEARCH), More 1 of 2 and PK TABLE ON OFF (ON) to turn on the peak table display.
3.The displayed peaks are listed by amplitude with the highest amplitude signal listed first. The table can be sorted by frequency, instead of amplitude. In this mode the lowest frequency peak is listed first, with the others listed in order of increasing frequency. Press PK SORT FRq AMP to underline FRQ and list the signals by frequency.
4.The harmonics are numbered on the display in order of their listing in the peak table. The table can be limited to list only the signals above a certain power level. Change the peak table from the normal mode to the display line mode by pressing PK MODE 0DL NRM to underline >DL. The knob can then be used to move the display line to identify only the desired peaks above the display line.
5.Press PK MODE <>DL NRM again to underline < DL and move the display line to identify only the peaks that fall below the display line.
NOTE
The peak table data can be printed by pressing the [CEF) key
The peak table cannot be saved or recalled.