HP Cable Box 8591C manual Preparing For Use

Preparing For Use

Turning on the Analyzer for the First Time

1.To calibrate the tracking generator, connect the tracking generator output (RF OUT 75 a2) to the cable TV analyzer INPUT 75 D connector, using an appropriate cable.

N O T E

A low-loss cable should be used for accurate calibration. Use the 75 0 cable shipped with the cable TV analyzer.

2. Press the following cable TV analyzer keys: ICAL), More 1 of 4 ,

More 2 of 4 , then CAL TRK GEM TG SIGNAL NOT FOUND will be displayed if the tracking generator output is not connected to the cable TV analyzer input.

3.To store this data in the area of cable TV analyzer memory that is stored when the cable TV analyzer is turned off, press CAL STORE

When the self-calibration routines have been completed successfully, the cable TV analyzer is ready for normal operation.

1-16