If You Have a Problem
Error Messages
RFPRESELERROR
Indicates that the preselector peak routine cannot be performed. (H)
RF PRESEL TIMEOUT
Indicates that the preselector peak routine cannot be performed. (H)
SAMPLE FAIL
Indicates the sample detector has failed. (H)
SETUP ERROR
Indicates that the span, channel bandwidth, or channel spacing are not set correctly for the adjacent channel power or channel power measurement. w>
SIGNAL NOT FOUND
Indicates the PEAK ZOOM routine did not End a valid signal. (U)
SIGNAL CLIPPED
Indicates that the current FFT measurement sweep resulted in a trace that is above the top graticule line on the cable TV analyzer display. If this happens, the input trace (trace A) has been “clipped,” and the FFT data is not valid. (U)
Signals do not fit expected % AM pattern
Indicates that the % AM routine cannot perform the percent AM measurement because the
Signals do not fit expected TO1 pattern
Indicates that the TO1 routine cannot perform the
SMPLR UNLCK
Indicates that the sampling oscillator circuitry is not functioning properly. If this message appears, check that the external frequency reference is correctly connected to the EXT REF INPUT. (U) and (H)
SOFTKEY OVFL
Softkey nesting exceeds the maximum number of levels. (U)