To replace the hard drive in the hard drive bay:
1Complete the instructions in "Before You Begin" on page 77.
2Turn the computer over, and remove the hard drive screws.
screws (2)
hard drive
NOTICE: When the hard drive is not in the computer, store it in protective antistatic packaging. See
"SAFETY: Protecting Against Electrostatic Discharge" on page 12.
3Slide the hard drive out of the computer.
4Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
NOTICE: Use firm and even pressure to slide the drive into place. If you use excessive force, you may damage the connector.
5Insert the drive into the bay, and push the hard drive until it is fully seated in the bay.
6Replace and tighten the screws.
7Use the Operating System CD to install the operating system for your computer (see page 73).
8Use the Drivers and Utilities CD to install the drivers and utilities for your computer (see page 69).
Adding and Replacing Parts
79
