Configuration via Telephone
You can edit the presettings and configure the Eumex 704PC LAN according to your personal requirements. There are three ways of doing this: you can use a PC and menus (see the chapter entitled "Configuring the System" on p. 66), a connected tele- phone (only possible with DTMF telephones), or the remote TeleService (0180 2 55 66 55). (0180 / 2 55 66 55).
Please see the chapter entitled "Remote Configuration" on p. 56.
To configure the system using a telephone, please proceed as follows:
•Start the configuration mode with your PIN (default setting is 0000).
•You start each configuration procedure by lifting the handset, and complete it by replacing the handset again after hearing a positive or negative acknowledgement tone.
•If you hear a negative acknowledgement tone, it means that the procedure has been aborted and your input has not been saved. Start the procedure again and make your input. When you hear a positive acknowledgement tone, this means that your input has been saved.
•Exit the configuration mode. If you do not exit the configuration mode manually, this will be done automatically four minutes after the last input.
As long as the configuration mode is active, call protection is automatically activated on the telephone used, which means that you cannot be called.
When you lift the handset in the configuration mode, you always hear a special inter- nal dialling tone.
If you attempt to configure the Eumex 704PC LAN via a telephone while it is already being configured via another telephone or a PC, you will hear a busy tone.
33
