VERTICAL TERMINATION (For All Models) (continued)
Reassembly and Resealing Vent Pipe System
Attach adapter pipe to vent cover in either the vertical or horizontal position, replace horizontal and vertical pipe lengths, elbows and horizontal or vertical termination kit.
All vent system components lock into place by sliding the concentric pipe section with four (4) equally spaced interior beads onto the appliance collar or previously installed component end with four (4) equally spaced indented sections. When the internal beads of each starting outer pipe line up, rotate pipe section clockwise 90° (approximately 3 inches). The vent pipe is now locked together.
Continue replacing components per the vent system configuration. Be certain that each succeeding vent component is securely fitted and locked into the preceding component in the vent system.
Reassembly and Resealing Gas Accumulation Relief System (Relief Doors) and Combustion Chamber
Whenever the relief door is pivoted open by a delayed ignition in the main burner, the relief door gaskets and combustion chamber must be examined by a qualified service person for damage. All damaged gaskets on the relief door and combustion chamber must be replaced by a qualified service person. If damage occurs to the combustion chamber, it must be replaced by a qualified service person. Contact Empire Comfort Systems, Inc. for replacement parts.
Vertical Through the Roof Applications (Figure 42)
Your Gas Fireplace has been approved for:
a) Vertical installations up to 25 feet in height.
b)Two sets of 45 degree elbow offsets within these vertical installations. From 0 to a maximum of 8 ft. a vent pipe can be used between elbows.
c)Wall straps must be used to support offset pipe every 4'.
This applications will require that you first determine the roof pitch and use the appropriate venting components.
Figure 42
LOG PLACEMENT
Before you begin: This unit is supplied with a set of five ceramic fiber logs. Do not handle these logs with your bare hands! Al- ways wear gloves to prevent skin irritation from ceramic fibers. After handling logs, wash your hands gently with soap and water to remove any traces of fibers.
Every burner is shipped with a shipping plate. This shipping plate must be removed before log placement.
The positioning of the logs is critical to the safe and clean opera- tion of this fireplace. Sooting and other problems may result if the logs are not properly and firmly positioned in the fireplace.
Glass Removal
1.Push up and outward to remove top louver.
2.Lower door assembly.
3.Release two door latches at bottom of firebox.
4.Grasp bottom of glass frame, lift glass frame upward in order to release glass frame from lip on top of firebox.
5.Remove shipping plate from burner pan.
6.Place two (2) log grates onto two (2) left, front pins and two
(2) right, front pins on burner pan. Secure grates with two (2) Tinnerman clips.
CORRECT GRATE INSTALLATION FOR 42" LOG SETS
INCORRECT GRATE INSTALLATION FOR 42" LOG SETS
Figure 43
Page 24 |
