Emerson Process Management GmbH & Co. OHG 1-15
X-STREAM XE
Instruction Manual
HASXEE-IM-HS
04/2010
1.5 X-STREAM XEGC: ½ 19 Inch Table-Top Unit
1.5 X-STREAM XEGC
This compact model for general purposes
can be tted with up to three photometer
measurement channels (IR or UV) and one
additional non-photometer channel (eO2, pO2
or WLD). Power is supplied by a separate
external power supply unit.
By default the units are congured for tabletop
use. For rack mounting an accessory kit can
be ordered to either install 2 units alongside,
or one single unit together with a blind pla-
te.
Connection to power supply
DC 24 V power is supplied via a 3-pin socket
at the rear of the unit.
Interfaces
Electrical connections for interface signals are
provided via submin-D connectors, Ethernet
and USB connectors mounted on the rear
panel of the device
(g. 1-5).
For applications where screw-type terminals
are preferred, optional adapters are available,
which are mounted directly onto the submin-D
connectors.
Interface signals
Detailed technical details on the various in-
terfaces can be found at 1-10. The con-
guration of the connectors and the optional
screw-type terminal adapters are described in
chapter 4 'Installation' and the software
settings in chapter 6 'Software'.
Gas connections
Depending on the conguration of the unit
(number of measurement channels and serial
or parallel connection), sample and calibra-
tion gases are fed into the unit via up to 6
tube ttings mounted on the rear panel. The
conguration of the ttings is indicated on an
adhesive label located near the tube ttings.
Any free tube ttings can be used for purging
the device
to minimize interference from the am-
bient atmosphere,
or
when measuring corrosive
and/or ammable gases.
1Technical Description