ADJUSTING THE PRINTER SETTINGS
I/F CONFIG. (Interface Configuration)
This feature allows you to configure your printer’s channels to match the signals output by your computer(s).
- Parallel Channel -
For the parallel channel, there are three settings. Normally, you do not have to change any of these unless you have special requirements.
❐SLCTIN: If SLCTIN is OFF, the printer is continuously selected and ignores device control codes DC1 and DC3. In almost all cases, leave SLCTIN set to OFF. When SLCTIN is ON, the SLCTIN signal goes HIGH at
Available Options: ON, OFF
❐AUTOFEED: If AUTOFEED is OFF, the printer ignores the AUTOFEED signal on pin 14 and does not send an automatic line feed (LF) command with each carriage re - turn (CR). If AUTOFEED is ON, the printer adds a line feed to each carriage return that it receives. If your text lines overprint each other, set AUTOFEED to ON. Available Options: ON, OFF
❐BUSY DELAY: Use this to set the delay period from the ACKNLG signal to the BUSY signal.
Available Options:
Factory Settings: SLCTIN: OFF, AUTOFEED:OFF, BUSY DELAY: 0
Example procedure: To switch AUTOFEED on.
1. Enter Level 2 mode (see page 34).
2. Press 
or 
until I/F CONFIG. is displayed.
3.
4.Press 
or 
until CH P CONFIG. is dis - played.
5.
6. Press 
or 
until AUTOFEED is displayed.
7. To change the current setting:
35
