![](/images/backgrounds/155949/bg38.png)
The printer prints a page and then stops
The display reads PAPER SIZE ERROR and the indicator blinks
❐You have selected the wrong paper size with your application software.
❐You may be trying to use a paper size that your printer cannot handle. Check your
fax machine’s specifications to see what paper sizes it can handle.
❐The P-SIZE setting may not match your paper size. Either:
If the indicator is out, press to clear the error. Then change the P-SIZE setting
(see page 27) if necessary.
If the indicator is on, check the current P-SIZE setting (see page 27) and put
some paper of the same size in the cassette. If the P-SIZE setting is incorrect,
press to reset the printer, then change the P-SIZE setting.
Caution: ❐When you reset the printer, any remaining data that was sent from the
computer will be lost.
❐If you continue to print using paper that is smaller than the paper size set
with your software, toner may accumulate inside the machine and dam -
age the master unit. Make sure that your software and P-SIZE settings
match the paper size in the cassette. If AUTO CONT is on, a paper size
error is detected but cleared automatically and printing continues. There -
fore, to avoid damage to your printer, keep AUTO CONT set to OFF (see
page 41).
PROBLEMS WITH GRAPHICSGraphic images do not print
After changing the emulation mode, you cannot print graphics
❐You may not have the correct printer driver installed. Set up your software package
to match your printer’s current emulation mode.
You cannot print graphics using the serial channel
❐The WORD LENGTH setting may not be correct (see page 36).When printing graph-
ics, this setting should be at 8.
When printing a mix of text and graphics, the page does not print or is only par-
tially printed. The display may also show SET FULL PRINT
❐Change the FULL PRINT setting (see page 29).
❐Your printer may not have enough memory. Simplify the page or install additional
memory (see page 10). To clear the error, press .
SOLVING PROBLEMS
50