ADJUSTING THE PRINTER SETTINGS
2.Press 
or 
until
3.
Note: CH P indicates that the setting on the screen is for the parallel channel. If
you wish to adjust the serial channel, now press 
or 
until you see CH S. Ignore CH O.
4.
5.Press 
or 
until the required setting is dis - played.
6. Store the displayed setting:
7.Either:
❐Press 
to cancel the new setting.
Go to step 4, or press 
three times to re - turn to printer standby mode.
❐Press 
to store the new setting. The printer resets itself and returns to printer "Ready" mode.
CH (Channel)
If you are only using one computer with the printer, you can ignore this section. If you are using two computers, read this section carefully before deciding what settings to use.
The CH feature gives you the choice of two settings to specify how the printer’s mem - ory is allocated to each channel. The CH setting has no effect on fax memory.
❐AUTOSENSE: The printer automatically detects which channel (parallel or serial) is receiving data, and allocates all the available printer memory to that channel.
❐INDIVIDUAL: You allocate a separate portion of the available memory for each channel.
AUTOSENSE is less complicated and requires less total memory. However, there is a small chance that files sent from two different computers at exactly the same time will interfere with each other. The INDIVIDUAL mode eliminates this possibility.
There are two ways to set up Autosense mode: AUTOSENSE P and AUTOSENSE S.
38
