3.Clear the Access the Internet using a proxy server check box.

Configuring the Network Interface Using EpsonNet Config

After you have assigned an IP address to the network interface using EpsonNet EasyInstall, EpsonNet Config for Windows or Macintosh, or the arp/ping command, you can configure the network interface using Web-based EpsonNet Config.

Note:

❏A Web browser must be installed on your computer.

❏TCP/IP must be correctly set for the computer and the network interface.

❏Do not run both EpsonNet Config for Windows or Macintosh and Web-based EpsonNet Config at the same time.

❏Your browser may restrict some characters you can use. For details, see your browser or operating system documentation.

❏If you are using the dial-up environment and not using NetWare, select Disable on the NetWare screen. If Enable is selected, the extra account may be charged when you are using the dial-up router.

Follow the steps below to change the IP address using EpsonNet Config.

1.Turn on the device.

2.Run EpsonNet Config using one of the following ways.

❏Run EpsonNet Config for Windows or Macintosh. Select the device you want to configure from the list and then click Launch Browser.

150