You have added or deleted protocols after installing EpsonNet Config.

Uninstall EpsonNet Config and then reinstall it. See “Uninstalling Software” and “Installing EpsonNet Config”.

The message “EpsonNet Config cannot be used because no network is installed.” appears when you start EpsonNet Config.

Cause

What to do

 

 

Both TCP/IP and IPX/SPX

Install the TCP/IP or IPX/SPX protocol.

are not installed on the

 

computer.

 

 

 

TCP/IP is installed on the

Set a correct IP address for the computer.

computer, but its IP address

 

is not set correctly.

 

The message “Could not complete communicating configuration data” appears when you send settings to the network interface.

Cause

What to do

 

 

This may happen when using

Run Command Prompt from the

a dial-up router.

computer on which EpsonNet Config is

 

installed, and then enter the following

 

command:

 

Format: >ROUTE_ADD_the IP address

 

of the network interface_ the IP address

 

of the computer (the under bar

 

represents one space)

 

Example:>ROUTEADD192.168.192.168

 

22.33.44.55.

Unable to start EpsonNet Config with Web Browser.

Cause

What to do

 

 

266